STRATUM LEVEL, A BREAK DOWN

This document breaks down stratum levels and defines minimum performance requirements for digital network
synchronization. Clock systems provide a stable frequency source during circuit impairments resulting in the connected
equipment not being affected until the clock holdover drift results in a slip. Since occasional slips will always occur, the
best one can do is to minimize their rate of occurrence. Through careful network engineering of the clock systems, near
perfect timing may be achieved at a reasonable cost with excellent reliability and maintainability.

A stable clock will change a network that experiences problems two or three times a day to one that maintains timing
through a major trunk outage. The network will continue to operate without impairment until the outage is repaired, as
long as the repair time is comparable to the time of the first frame slip (see Table 1).

The requirements for the stratum levels are shown in Table 1, which provides a comparison and summary of the drift
and slip rates for the strata clock systems. Clocks of higher stratum levels can be used to control lower strata levels.
In a case where more than one Stratum 1 source is used, it is advisable to trace these clocks back to some other
standard to ensure that these sources are accurate.

StratumAccuracyStabiltyPull-In-Range*Time to frame slip
10.01ppbN/AN/A72 Days
216ppb.1ppb/Day16ppb7 Days
31ppm10ppb/Day4.6ppm3.5 Hours
3E4.6ppm370ppb/Day4.6ppm6 Minutes
* To calculate slip rate from drift, one assumes a frequency offset equal to the above drift in 24 hours, which accumulates bit slips until 193 bits have been accumulated. Drift rates for various atomic and crystal oscillators are not usually linear or not necessarily continually increasing.

Stratum 1 is defined as a completely autonomous source of timing, which has no other input, other than perhaps a
yearly calibration. The usual source of Stratum 1 timing is an atomic standard (Cesium Beam or Hydrogen Maser) or
reference oscillator (OCXO). A properly calibrated source will provide bit-stream timing that will not slip relative to an
absolute or perfect standard more than once every 4 to 5 months. Atomic standards, such as Cesium clocks, have far
better performance. A Stratum 1 clock is a Primary Reference Source. An example is: a clock system employing direct
control from Coordinated Universal Time (UTC) frequency and time services, such as a Global Positioning System (GPS).
The GPS System may be used to provide high accuracy, low cost timing of Stratum 1 quality.

A Stratum 2 clock system tracks an input under normal operating conditions and holds to the last best estimate of the
input reference frequency during impaired operating conditions.
Typical examples of Stratum 2 clocks are Rubidium Standards and Double Oven OCXO’s.

Stratum 3 is defined as a clock system which tracks an input as in Stratum 2, but over a wider range. Some Stratum 3
clock equipment is not adequate to time SONET network elements. Stratum 3E is a new standard created as a result of
SONET equipment requirements.

A PDF version of these notes is available here.

If you require additional information, contact us by phone at (949) 783-7300 or e-mail [email protected]

Menu